Perkins 1106D Disassembly And Assembly page 60

60
Disassembly and Assembly Section
Note: The setscrews are different lengths. Ensure
that the different setscrews are installed in the correct
location.
6. Install the joint (16) to the assembly of the oil
cooler (6). Push the setscrews (7) through the
holes in the joint.
Note: The holes in the joint have serrations that hold
the setscrews captive.
Installation Procedure
1. Clean the joint face of the cylinder block.
Illustration 107
Typical example of an engine oil cooler with a blanking plate
Illustration 108
Typical example of an engine oil cooler with a high mounted filter
base
2. Install the assembly of the oil cooler (6) to the
cylinder block. Tighten the setscrews (7) finger
tight.
If the engine has a high mounted oil filter base,
install the oil filter base (14) finger tight. Refer
to Illustration 108 and refer to Disassembly and
Assembly Manual, "Engine Oil Filter Base -
Remove and Install".
g01181109
Illustration 109
Tightening sequence for an engine oil cooler with a blanking plate
or with a low mounted oil filter base
SENR9983
g01204901
g01179352