Perkins 1106D Disassembly And Assembly page 78

78
Disassembly and Assembly Section
Illustration 142
5. Remove the joint (7). Discard the joint.
6. If necessary, remove the two dowels (5) from the
cylinder block.
7. Remove the oil seal (8) from the flywheel housing
(1). Discard the oil seal.
Installation Procedure (Standard
Housing)
Table 29
Required Tools
Part
Tool
Number
Guide Stud
-
A
(M10 by 100 mm)
POWERPART
1861117
B Universal Jointing
Compound
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
1. Ensure that the flywheel housing is clean and free
from damage. If necessary, replace the flywheel
housing.
g01215183
Part Description Qty
2
1
Illustration 143
Engine with an aluminum oil pan
Illustration 144
Engine with a cast iron oil pan
2. Inspect the crankshaft rear seal (8) for leaks. If
there are any oil leaks, replace the crankshaft rear
seal. Refer to Disassembly and Assembly Manual,
"Crankshaft Rear Seal - Remove" and refer to
Disassembly and Assembly Manual, "Crankshaft
Rear Seal - Install".
3. Clean the rear face of the cylinder block. If
necessary, install the two dowels (4) to the cylinder
block.
4. Install the Tooling (A) to the cylinder block.
5. If the engine has an aluminum oil pan, install the
dust seal (5).
If the engine has a cast iron oil pan, apply a bead
of Tooling (B) to positions (X).
SENR9983
g01202954
g01202955