Perkins 1106D Disassembly And Assembly page 34

34
Disassembly and Assembly Section
NOTICE
Care must be taken to ensure that fluids are contained
during performance of inspection, maintenance, test-
ing, adjusting and repair of the product. Be prepared to
collect the fluid with suitable containers before open-
ing any compartment or disassembling any compo-
nent containing fluids.
Dispose of all fluids according to local regulations and
mandates.
1. Disconnect the air hose for the turbocharger inlet
and for the turbocharger outlet (not shown). Refer
to OEM information for the correct procedure.
2. If the turbocharger has a remote wastegate
solenoid, disconnect the hose to the solenoid (not
shown) from the turbocharger.
3. Disconnect the exhaust pipe (not shown). Refer to
OEM information for the correct procedure.
4. If the turbocharger has an exhaust elbow,
remove the exhaust elbow (not shown). Refer to
Disassembly and Assembly Manual, "Exhaust
Elbow - Remove and Install".
Illustration 63
5. Remove the two setscrews (5) in order to
disconnect the tube assembly (4) from the cylinder
block. Remove the joint (3). Discard the joint.
6. Remove the setscrew (8) in order to disconnect
the tube assembly (7) from the cylinder block.
7. Remove the fasteners for the tube clips (2).
8. Loosen the four nuts (11). Refer to Illustration 64.
9. Remove the exhaust manifold (1) and the
assembly of the turbocharger from the cylinder
head. Refer to Disassembly and Assembly
Manual, "Exhaust Manifold - Remove and Install"
for the correct procedure.
Illustration 64
10. Remove the banjo bolt (9) and remove the tube
assembly (7) for the oil feed from the turbocharger
(12). Remove the two sealing washers (10).
Discard the sealing washers.
Note: Plug the port for the oil feed to the turbocharger
with a suitable plug.
g01183875
11. Remove the O-ring seal (6) from the tube
assembly (7). Refer to Illustration 63. Discard the
O-ring seal.
SENR9983
g01185011