Perkins 1106D Disassembly And Assembly page 47

SENR9983
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
1. Disconnect the breather hose from the separator
for the crankcase breather (not shown). Refer to
Disassembly and Assembly Manual, "Crankcase
Breather - Remove".
Illustration 85
2. Cut the cable ties that secure the harness
assembly (not shown) to the inlet manifold (4).
Position the harness assembly away from the inlet
manifold.
3. Remove the setscrews (1) from the inlet
connection (2).
4. Remove the inlet connection (2) and the gasket
(3) from the inlet manifold (4). Discard the gasket.
5. Remove the setscrews (5).
6. Remove the inlet manifold (4) from the cylinder
head. Use a suitable tool to pry the inlet manifold
from the cylinder head. Use the recess at position
(X) to pry the inlet manifold.
7. Remove the inlet manifold seal (6) from the recess
in the inlet manifold (4). Discard the seal.
8. Do not remove the two dowel pins (7).
Installation Procedure
Table 15
Tool
A
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
g01208825
Illustration 86
1. Ensure that the inlet manifold is clean and free
from damage. If necessary, replace the inlet
manifold. If a new inlet manifold is installed, install
two new dowel pins (7) to the inlet manifold (4).
Note: Do not install dowel pins to the cylinder head.
2. Clean the joint face of the cylinder head.
3. Align the tag (8) to the slot at position (Y) on
the inlet manifold. Install the new seal (6) to the
groove in the inlet manifold (4). Ensure that the
seal is correctly located.
Disassembly and Assembly Section
Required Tools
Part
Part Name
Number
-
3 bond 1368D
NOTICE
47
Qty
1
g01215536