Perkins 1106D Disassembly And Assembly page 33

SENR9983
Illustration 61
5. Follow Steps 5.a through 5.c in order to remove
the tube assembly (4) for the oil feed.
a. Remove the setscrew (5).
b. Remove the banjo bolt (1) and remove the
two sealing washers (2). Discard the sealing
washers.
c. Remove the tube assembly (3) from the
cylinder block. Remove the O-ring seal (4) from
the tube assembly. Discard the O-ring seal.
Note: Plug the port for the oil feed to the turbocharger
with a suitable plug.
6. Follow Steps 6 through 6.c in order to remove the
tube assembly (10) for the oil drain.
a. Remove the two setscrews (11).
b. Remove the two setscrews (8) and remove the
tube assembly (10) from the turbocharger (6).
c. Remove the joint (7) and remove the joint (9).
Discard the joints.
Illustration 62
7. Remove the four nuts (15) from the turbocharger
(6) and remove the turbocharger (6) from the
exhaust manifold (12).
Note: Ensure that the weight of the turbocharger is
g01165546
supported as the nuts are loosened.
8. Remove the joint (14). Discard the joint.
9. If necessary, remove the four studs (13) from the
exhaust manifold (12).
Removal Procedure (Top Mounted
Turbochargers)
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Disassembly and Assembly Section
NOTICE
33
g01171991