Perkins 1106D Disassembly And Assembly page 77

SENR9983
Illustration 138
2. Remove the two M12 setscrews (2) and six M10
setscrews (3) from the flywheel housing (1).
3. Use the lifting device in order to remove the
flywheel housing (1) from the cylinder block.
Illustration 139
Typical example
4. If the engine has an aluminum oil pan, remove
the dust seal (5).
5. If necessary, remove the two dowels (4) from the
cylinder block.
Removal Procedure (Wet Back End
Housing)
Start By:
a. Remove the flywheel. Refer to Disassembly and
Assembly Manual, "Flywheel - Remove".
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
1. Install a suitable lifting device to the flywheel
housing in order to support the flywheel housing.
The flywheel housing can weigh 32 kg (70.5 lb).
g01165544
Illustration 140
2. Remove the two M16 setscrews (2). Remove the
two M12 setscrews (4). Remove the four M10
setscrews (3) from the flywheel housing (1).
3. Use the lifting device in order to remove the
flywheel housing (1) from the cylinder block.
g01202952
Illustration 141
Typical example
4. If the engine has an aluminum oil pan, remove
the dust seal (6).
Disassembly and Assembly Section
NOTICE
77
g01202953
g01215182