Perkins 1106D Disassembly And Assembly page 105

SENR9983
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Illustration 207
Breather tool
1. To install the breather body, Tooling (A) must be
used. The tool should be fabricated from 3.1 mm
(1/8 inch) steel stock. The dimensions for the tool
are given in Illustration 207. All dimensions are
shown in millimeters.
Illustration 208
2. Ensure that all components of the crankcase
breather are clean and free from damage. Replace
any components that are damaged.
3. Lubricate a new O-ring seal (9) with clean engine
g01206039
oil. Install the O-ring seal to the adapter plate (8).
4. Install the adapter plate (8) to the valve mechanism
cover (10).
5. Install the washers (7) and the two setscrews (6)
to the adapter plate (8). Tighten the setscrews to
a torque of 4.4 N·m (38 lb in).
6. Lubricate a new O-ring seal (5) with clean engine
oil. Install the O-ring seal to the bottom of the
breather body (4).
7. Use Tooling (A) in order to screw the breather
body (4) into the adapter plate (8). Tighten the
breather body to a torque of 8 N·m (71 lb in).
8. Install the gauze (2) into the breather body (4).
9. Lubricate a new O-ring seal (3) with clean engine
oil. Install the O-ring seal to the top of the breather
body (4).
Disassembly and Assembly Section
105
g01200785