Perkins 1106D Disassembly And Assembly page 174

174
Disassembly and Assembly Section
Illustration 355
2. Position the mounting bracket (8) against the
cylinder block. Ensure that the two slots in the top
face of the mounting bracket are aligned with the
setscrews (11). Slide the mounting bracket into
position against the cylinder block.
3. Install the four setscrews (12) finger tight.
4. Install the three setscrews (9) that secure the fuel
manifold (10) to the mounting bracket (8) finger
tight.
Note: Ensure that the fuel manifold is seated against
the mounting bracket before the setscrews (9) are
tightened. Ensure that the fuel injection lines are not
stressed when the setscrews are tightened.
5. Tighten the two setscrews (11) to a torque of
22 N·m (16 lb ft).
6. Tighten the four setscrews (12) to a torque of
22 N·m (16 lb ft). Tighten the three setscrews (9)
to a torque of 22 N·m (16 lb ft).
g01202608
Illustration 356
7. Install the terminal insulator (6) to the mounting
bracket (8). Connect the wire (7) to the terminal
insulator. Refer to Disassembly and Assembly
Manual, "Glow Plugs - Remove and Install" for the
correct procedure.
8. Follow Steps 1.b through 1.c in order to connect
the engine wiring harness (2).
a. Connect the harness assembly (2) to the fuel
pressure sensor (3).
b. Slide the locking tab (4) into the locked position.
c. Position the harness assembly (2) onto the
mounting bracket (8). Use two new cable ties
(1) and (5) in order to secure the harness
assembly.
End By:
a. Install the electronic control module. Refer to
Disassembly and Assembly Manual, "Electronic
Control Module - Remove and Install".
SENR9983
g01202607