Perkins 1106D Disassembly And Assembly page 121

SENR9983
Illustration 248
Typical example
20. Follow Steps 20.a and 20.b in order to connect the
harness assembly (4) to the inlet air temperature
sensor (7).
a. Connect the harness assembly (4) to the inlet
air temperature sensor (7).
b. Slide the locking tab (not shown) into the
locked position.
21. Follow Steps 21.a and 21.b in order to connect
the harness assembly (4) to the boost pressure
sensor (6).
a. Connect the harness assembly (4) to the boost
pressure sensor (6).
b. Slide the locking tab (not shown) into the
locked position.
22. Follow Steps 22.a and 22.b in order to connect the
harness assembly (4) to the coolant temperature
sensor (5).
a. Connect the harness assembly (4) to the
coolant temperature sensor (5).
b. Slide the locking tab (not shown) into the
locked position.
23. Use new cable ties in order to secure the harness
assembly to the cylinder head and to the inlet
manifold. Ensure that the harness assembly is not
strained.
Note: Ensure that the harness assembly is clear of
other engine components.
24. Install the inlet hose (not shown) to the inlet
connection (3) on the inlet manifold (2).
g01175424
Illustration 249
Typical example
25. If necessary, install the water temperature
regulator housing (1) to the cylinder head. Refer
to Disassembly and Assembly Manual, "Water
Temperature Regulator Housing - Remove and
Install".
26. Connect the upper radiator hose (not shown) to
the water temperature regulator housing (1) on
the cylinder head.
27. Fill the cooling system with coolant. Refer to
Operation and Maintenance Manual, "Cooling
System Coolant - Change" for the correct filling
procedure.
28. If necessary, fill the engine oil pan to the correct
level that is indicated on the engine oil level
gauge. Refer to Operation and Maintenance
Manual, "Engine Oil Level - Check".
End By:
a. Install the glow plugs. Refer to Disassembly and
Assembly Manual, "Glow Plugs - Remove and
Install".
b. Install the valve mechanism cover base. Refer
to Disassembly and Assembly Manual, "Valve
Mechanism Cover Base - Install".
c. Install the electronic unit injectors. Refer to
Disassembly and Assembly Manual, "Electronic
Unit Injector - Remove".
d. Install the electronic control module and the
mounting bracket. Refer to Disassembly and
Assembly Manual, "Electronic Control Module -
Remove and Install".
e. Install the fuel manifold. Refer to Disassembly and
Assembly Manual, "Fuel Manifold - Remove and
Install".
Disassembly and Assembly Section
121
g01176154