Perkins 1106D Disassembly And Assembly page 15

SENR9983
Illustration 21
The fuel manifold is shown with fuel injection lines in position.
1. If the fuel sensor (4) has not been removed from
the fuel manifold (1), slide the locking tab (3) into
the unlocked position. Disconnect the plug on
the harness assembly (6) from the fuel pressure
sensor (4).
2. Disconnect the tube assembly (5) from the fuel
pressure relief valve on the fuel manifold (1).
Immediately cap the open port in the fuel manifold
(1) with a new cap. Immediately plug the open end
of the tube assembly (5) with a new plug.
3. Remove the three setscrews (2) from the fuel
manifold (1).
4. Remove the fuel manifold (1) from the mounting
bracket (7).
Installation Procedure
NOTICE
Ensure that all adjustments and repairs that are
carried out to the fuel system are performed by
authorised personnel that have the correct train-
ing.
Before begining ANY work on the fuel system, re-
fer to Operation and Maintenance Manual, "Gen-
eral Hazard Information and High Pressure Fuel
Lines" for safety information.
Refer to Testing and Adjusting Manual, "Clean-
liness of Fuel System Components" for detailed
information on the standards of cleanliness that
must be observed during ALL work on the fuel
system.
1. Ensure that all ports on the fuel manifold are
capped. Ensure that the fuel manifold is externally
clean and free from damage.
Note: Do not install a fuel manifold that has not
been capped. All caps must be left in place until the
fuel injection lines or the fuel pressure sensor are
installed.
g01190733
Illustration 22
The fuel manifold is shown with fuel injection lines in position.
2. Position the fuel manifold (1) on the mounting
bracket (7).
3. Install the three setscrews (2) to the fuel manifold
(1) finger tight.
4. Install a new set of fuel injection lines and seals.
Refer to Disassembly and Assembly Manual,
"Fuel Injection Lines - Install" for more information.
5. Tighten the setscrews (2) to a torque of 22 N·m
(16 lb ft).
6. Remove the plug from the tube assembly (5).
Remove the cap from the appropriate port in the
fuel manifold (1). Connect the tube assembly
(5) to the fuel pressure relief valve on the fuel
manifold (1).
7. If the fuel pressure sensor (4) was not removed
from the fuel manifold (1), connect the plug on
the harness assembly (6) to the fuel pressure
sensor (4). slide the locking tab (3) into the locked
position.
Disassembly and Assembly Section
15
g01190733