Perkins 1106D Disassembly And Assembly page 21

SENR9983
Illustration 30
Typical example
Illustration 31
Typical example
15. Remove the appropriate plugs and caps in order
to install tube assembly (9) for the engine oil
supply to the fuel injection pump. Install the tube
assembly (9). Tighten the nuts at both ends of the
tube assembly.
16. Remove the appropriate caps in order to install
the fuel injection line (6). Install a new fuel injection
line (6) to the fuel injection pump and to the fuel
manifold. Refer to Disassembly and Assembly
Manual, "Fuel Injection Lines - Install".
17. Remove the plugs and caps from the remaining
ports and tube assemblies.
18. Install the tube assembly (12) for the fuel return
to the fuel transfer pump and to the cylinder
head. Tighten the nuts at both ends of the tube
assembly.
19. Install the plastic tube assembly (5) to the fuel
injection pump (1).
20. Install the plastic tube assembly (10) for the fuel
outlet to the fuel transfer pump (8).
21. Install the plastic tube assembly (11) to the fuel
transfer pump (8).
g01173307
22. Connect the harness assembly (7) to the solenoid
(3) on the fuel injection pump. Connect the
harness assembly (7) to the position sensor (4) on
the fuel injection pump. Slide the locking tab (not
shown) into the locked position.
23. If necessary, install the fuel priming pump. Refer
to Disassembly and Assembly Manual, "Fuel
Priming Pump - Remove and Install".
24. If necessary, install the fuel filter base. Refer to
Disassembly and Assembly Manual, "Fuel Filter
Base - Remove and Install".
25. Restore the fuel supply.
26. Restore the electrical supply.
27. Remove the air from the fuel system. Refer to
Operation and Maintenance Manual, "Fuel System
- Prime" for more information.
g01173310
Disassembly and Assembly Section
21