Perkins 1106D Disassembly And Assembly page 133

SENR9983
d. Position a new joint (10) onto the isolating
frame (12).
e. Align the isolating frame (10) with Tooling (B).
Install the isolating frame to the cylinder block.
f. Use Tooling (A) to install the two torx screws
(11) and the four torx screws (13) to the
isolating frame. Tighten the torx screws (11) to
a torque of 22 N·m (16 lb ft). Tighten the torx
screws (13) to a torque of 22 N·m (16 lb ft).
Illustration 276
3. Ensure that the engine oil pan (7) is clean and free
from damage. Clean the isolating screws (8) and
(9). Inspect the isolating screws for deterioration
or damage. If necessary, replace the isolating
screws. If necessary, ensure that the joint face of
the isolating frame is clean.
Note: The isolating screws must be replaced as a
complete set in order to ensure the correct clamping
of the engine oil pan.
4. Position a new joint (4) onto the engine oil pan (7).
5. Install the isolating screws (8) and (9) to the
engine oil pan. Do not install the isolating screws
(8) in positions (X). Refer to Illustration 273.
Note: The isolating screws are held captive by the
joint.
6. Align the assembly of the engine oil pan with
Tooling (B). Install the assembly of the engine
oil pan to the isolating frame (12). Install the clip
that secures the breather hose (not shown) in the
correct position.
g01176667
Disassembly and Assembly Section
133