Perkins 1106D Disassembly And Assembly page 5

SENR9983
Removal Procedure (Electric Fuel
Priming Pump)
NOTICE
Ensure that all adjustments and repairs that are
carried out to the fuel system are performed by
authorised personnel that have the correct train-
ing.
Before begining ANY work on the fuel system, re-
fer to Operation and Maintenance Manual, "Gen-
eral Hazard Information and High Pressure Fuel
Lines" for safety information.
Refer to Testing and Adjusting Manual, "Clean-
liness of Fuel System Components" for detailed
information on the standards of cleanliness that
must be observed during ALL work on the fuel
system.
1. Isolate the fuel supply.
Illustration 2
Typical example
2. Isolate the electrical supply.
3. Disconnect the electrical lead (3) for the electric
priming pump (4).
4. Make a temporary identification mark on the
plastic tube assemblies (1) and (2) in order to
show the correct position of the tube assemblies.
5. Disconnect the plastic tube assemblies (1) and (2).
Plug the tube assemblies with new plugs. Cap the
ports in the fuel priming pump (4) with new caps.
6. Remove the four setscrews (5) from the electric
priming pump (4).
7. Remove the electric priming pump (4) from the
mounting bracket.
Installation Procedure (Manual
Priming Pump)
Ensure that all adjustments and repairs that are
carried out to the fuel system are performed by
authorised personnel that have the correct train-
ing.
Before begining ANY work on the fuel system, re-
fer to Operation and Maintenance Manual, "Gen-
eral Hazard Information and High Pressure Fuel
Lines" for safety information.
Refer to Testing and Adjusting Manual, "Clean-
liness of Fuel System Components" for detailed
information on the standards of cleanliness that
must be observed during ALL work on the fuel
system.
1. Ensure that the fuel priming pump (4) is clean and
free from wear or damage. If necessary, replace
the fuel priming pump.
g01186418
Illustration 3
Typical example
2. If necessary, follow Steps 2.a through 2.d in order
to assemble the fuel priming pump (4).
a. Install new O-ring seals (3) to the connectors
(2) and to the plugs (5).
b. Install the connectors (2) to the fuel priming
pump (4).
c. Install the plugs (5) to the fuel priming pump (4).
Disassembly and Assembly Section
NOTICE
5
g01181971