134
Disassembly and Assembly Section
Illustration 277
(X) Position of guide studs.
(Z) Position of short isolating screws.
7. Tighten the isolating screws to a torque of 22 N·m
(16 lb ft). Tighten the isolating screws in the
sequence that is shown in Illustration 277.
8. Remove Tooling (B).
Illustration 278
9. Install the four remaining isolating screws. Tighten
the isolating screws to a torque of 22 N·m (16 lb ft).
Tighten the isolating screws in the sequence that
is shown in Illustration 278.
10. Install a new O-ring seal (6) to the drain plug (5).
Install the drain plug (5) to the engine oil pan (7).
Refer to Illustration 276. Tighten the oil drain plug
to a torque of 34 N·m (25 lb ft).
SENR9983
g01215571
g01184167