Engine Oil Cooler - Remove - Perkins 1106D Disassembly And Assembly

56
Disassembly and Assembly Section
7. If necessary, remove the plug (8) from the engine
oil filter base (2). Remove the O-ring seal (7) from
the plug (8). Discard the O-ring seal.
Installation Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Illustration 97
Typical example
1. Clean the engine oil filter base (2). Clean the
mating surfaces of the cylinder block or the engine
oil cooler.
2. If necessary, install new O-ring seals (5) and (7) to
the plugs (6) and (8). Install the plugs (6) and (8)
to the engine oil filter base (2). Tighten the plugs
to a torque of 12 N·m (106 lb in).
Note: Drain plug (8) is only installed to engines with
a horizontal engine oil filter.
3. Install the setscrews (4) to the engine oil filter base
(2). Ensure that setscrews of different lengths are
installed in the correct positions.
Note: If necessary, install the spacers and the
bracket for the wiring loom.
4. Install a new joint (1) onto the setscrews (4). Install
the assembly of the engine oil filter base to the
cylinder block or the engine oil cooler.
5. Tighten the setscrews (4) to a torque of 22 N·m
(16 lb ft).
6. Install a new engine oil filter (3) and check the level
of the engine lubricating oil. Refer to Operation
and Maintenance Manual, "Engine Oil Level -
Check" for the correct procedure.

Engine Oil Cooler - Remove

Removal Procedure
Start By:
a. Remove the bracket for the Electronic Control
Module. Refer to Disassembly and Assembly
Manual, "ECM Mounting Bracket - Remove and
Install".
Ensure that all adjustments and repairs that are
carried out to the fuel system are performed by
authorised personnel that have the correct train-
ing.
Before begining ANY work on the fuel system, re-
fer to Operation and Maintenance Manual, "Gen-
eral Hazard Information and High Pressure Fuel
Lines" for safety information.
Refer to Testing and Adjusting Manual, "Clean-
g01162867
liness of Fuel System Components" for detailed
information on the standards of cleanliness that
must be observed during ALL work on the fuel
system.
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Care must be taken to ensure that fluids are contained
during performance of inspection, maintenance, test-
ing, adjusting and repair of the product. Be prepared to
collect the fluid with suitable containers before open-
ing any compartment or disassembling any compo-
nent containing fluids.
Dispose of all fluids according to local regulations and
mandates.
1. Drain the coolant from the cooling system into
a suitable container. Refer to Operation and
Maintenance Manual, "Cooling System Coolant -
Drain" for the correct procedure.
2. Place a suitable container below the engine oil
cooler in order to catch any fluids that might be
spilled.
SENR9983
i02296106
NOTICE
NOTICE
NOTICE