Perkins 1106D Disassembly And Assembly page 89

SENR9983
Illustration 162
3. Remove the plug (4) from the cylinder block. Install
Tooling (C) into the hole (Y) in the cylinder block.
Use Tooling (C) in order to lock the crankshaft in
the correct position. Refer to Testing and Adjusting
Manual, "Finding Top Centre Position for No.1
Piston".
Note: Do not use excessive force to install Tooling
(C). Do not use Tooling (C) to hold the crankshaft
during repairs.
Illustration 163
4. Loosen the nuts (6) on all rocker arms (7).
Unscrew the adjusters (5) on all rocker arms (7)
until all valves are fully closed.
Note: Failure to ensure that ALL adjusters are fully
unscrewed can result in contact between the valves
and pistons.
5. Apply sufficient pressure to the fuel injection pump
gear (3) in a counterclockwise direction in order
to remove the backlash. Lock the fuel injection
pump in this position. Refer to Disassembly and
Assembly, "Fuel Pump Gear - Remove" for the
correct procedure.
g01195325
Illustration 164
Typical example
6. Mark the gears (1), (2) and (3) in order to show
alignment. Refer to Illustration 164.
Note: Identification will ensure that the gears can be
installed in the original alignment.
7. Remove the fuel pump gear (3). Refer to
Disassembly and Assembly, "Fuel Pump Gear -
Remove and Install" for the correct procedure.
8. Remove the camshaft gear (1). Refer to
Disassembly and Assembly Manual, "Camshaft
Gear - Remove and Install".
9. Remove the idler gear (2). Refer to Disassembly
and Assembly Manual, "Idler Gear - Remove and
Install".
g01198767
Installation Procedure
Table 40
Tool
27610212
B
27610286
C
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Note: The fuel injection pump must remain locked
until the procedure instructs you to unlock the fuel
injection pump.
1. Ensure that number one piston is at top dead
center on the compression stroke. Refer to the
Testing and Adjusting Manual, "Finding Top Center
for No. 1 Piston".
Disassembly and Assembly Section
Required Tools
Part
Part Name
Number
Camshaft Timing Pin
Crankshaft Timing Pin
NOTICE
89
g01194949
Qty
1
1