Perkins 1106D Disassembly And Assembly page 173

SENR9983
Illustration 351
1. Follow Steps 1.a through 1.c in order to disconnect
the engine wiring harness (2) .
a. Slide the locking tab (4) into the unlocked
position.
b. Disconnect the harness assembly (2) from the
fuel pressure sensor (3).
c. Cut the two cable ties (1) and (5). Position
the harness assembly (2) so that the harness
assembly is clear of the mounting bracket (8).
2. Disconnect the wire (7) for the glow plugs.
Remove the terminal insulator (6) from the
mounting bracket (8). Refer to Disassembly and
Assembly Manual, "Glow Plugs - Remove and
Install" for the correct procedure.
Illustration 352
3. Remove the three setscrews (9) from the fuel
manifold (10).
4. Loosen the two setscrews (11) that secure the
mounting bracket (8) to the inlet manifold.
Illustration 353
5. Remove the four setscrews (12) that secure the
mounting bracket (8) to the cylinder block.
6. Slide the mounting bracket (8) horizontally away
from the cylinder block in order to remove the
g01202607
mounting bracket.
Note: Avoid placing any strain on the fuel injection
lines when the fuel manifold is not supported by the
mounting bracket.
Installation Procedure
1. Ensure that the mounting bracket for the electronic
control module is clean and free from damage.
If the mounting bracket is damaged, replace the
bracket.
Illustration 354
g01202608
Disassembly and Assembly Section
173
g01177811
g01177811