Ricoh Pro C7200S Operator's Manual page 450

11. Troubleshooting
Message
"Exceeded the maximum
number of OCR jobs that can
be on standby for storing,
please wait. Try again after
storing of the current job has
completed."
"File types have been
automatically set for some
files because multiple files
were selected."
"Programmed. Cannot
program the destination(s)
that is not programmed in the
address book."
"Scanner journal is full.
Please check Scanner
Features."
448
Cause
The maximum allowable
number of jobs on standby was
exceeded because large
quantities of documents were
stored by the OCR function.
If there are selected stored
documents which cannot be
converted to a specified file
format, those documents are
automatically converted to a
convertible format before they
are transmitted.
The destinations that were
selected while registered to the
program contain a folder
destination for which one of the
following destinations is set:
manually entered destination,
WSD destination, or DSM
destination
"Print & Delete Scanner Journal"
in [Scanner Features] is set to
[Do not Print: Disable Send],
and Scanner Journal is full.
Solution
Up to 100 jobs can be placed on
standby by the OCR function.
Scan the next document after the
current jobs have finished being
stored.
For details about the file formats
used to transmit stored documents,
see page 388 "Sending a Stored
File".
WSD destinations and DSM
destinations cannot be registered
to the program because they
cannot be registered in the
address book. For manually
entered destinations, register the
destinations in the address book,
and then try to register them to the
program again.
Print or delete Scanner Journal. For
details about Scanner Features,
see "General Settings",
Preparation.