Bowflex BXE116 Service Manual page 95

14. Using a small standard screwdriver, gently pry the Cap off of the
center of the Right Crank Cover.
15. Using a #2 Phillips screwdriver, remove the 6 indicated screws (ovals
and arrows) from the Right Crank Cover.
NOTICE: To assist with re-assembly, observe that the white arrows
are the longer screws.
16. Observe the cable routing from the Motor Control Board (MCB)
Assembly on your machine.
• Power Inlet Cable (Power switch to MCB)
• Lift Motor Cable, Lower (Lift Motor to MCB)
• Lift Motor Wire, Upper (MCB to Console)
• Servo Control Wire (MCB to Servo Motor)
• Speed Sensor Cable (Speed Sensor to Servo Motor)
• Input/Output (I/O) Cable (Servo Motor to Console)
Note: Be sure to note where all cables are routed for re-assembly.
Lift Motor Cable
MCB
Cover
95
Crank Cover
Cap (removed from
center of Crank Cover)
Input/Output (I/O) Cable
Lift Motor Cable