8. Using a small Standard screwdriver, remove the indicated Cap (by ar-
row) from the Frame Assembly.
9. Using a 6mm hex wrench, remove the indicated hardware from the
Crank Arm and Leg.
10. Remove the Interior Pivot Cover while noting how the Handlebar
Cable runs through it for re-assembly.
11. Using a 6mm hex key, loosen and remove the indicated hardware from
the Crank Arm and Leg, and set it safely aside for reassembly. Remove
the Leg and Pedal together and set them safely aside for reassembly.
NOTICE: This step may require two people.
12. Repeat steps 2-11 on the other side of the machine.
13. Using a #2 Phillips screwdriver,
remove the screws that secure the
Upper Shrouds and Tray.
Note: Be sure to observe how the
Handlebar Cables route through
the Upper Shrouds to assist with
re-assembly.
X4
F
X2
122