Bowflex BXE116 Service Manual page 29

9. Insert 2.5" x 10" cardboard between the Flywheel and the Brake
Magnet, and tape the cardboard to the Brake Magnet.
Note: Be sure the cardboard covers all of the Brake Magnet.
Flywheel
10. To adjust the Brake tension, loosen the 2 hex head bolts and move
the Servo Motor assembly until the closest point on the Brake Magnet is
within 3.0mm (1/8") of the Flywheel. Tighten the bolts.
Note: I f the cardboard is not 3mm (1/8") thick, you can use the pages of
a paperback book to measure the gap. Approximately 36 pages
(sheets) = 3mm.
11. Remove the cardboard from between the Brake Magnet and the
Flywheel.
12. Before fully attaching the Shrouds, power up the machine to verify that
the Magnet Arm can move freely, and that the Brake Magnet and Flywheel
do not touch at the maximum resistance level.
Machine is on. Current is active. There is risk of electrical
!
shock. Be sure to keep fingers clear of all pinch hazards when
you change the resistance level.
13. Turn the power switch to off and disconnect all power and allow to sit
for 5 minutes.
To reduce the risk of electrical shock or unsuper-
!
vised usage of the equipment, always unplug the
power cord from the wall outlet and wait 5 minutes
before cleaning, maintaining or repairing this
machine. Place the power cord in a secure
location.
Brake Magnet
29
Servo Motor
Brake Magnet
Flywheel