Bowflex BXE116 Service Manual page 38

3. Gently lift and remove the Console/Static Handlebar Assembly from the
Console Mast and disconnect the five cables (the Input/Output, Lift Motor,
Resistance Control, Wireless Heart Rate, and Incline Control Cables) that
come from the back of the Console.
Note: Do not let the Cables fall down inside the Console Mast. If neces-
sary, use a rubber band or wire tie to secure them. This step may require
two people.
4. Using a #2 Phillips screwdriver, remove the four indicated screws from
the Console and remove the Static Handlebar.
Note: Be sure to observe how the cables route through the Static Handle-
bar from the Console before removing it to assist with re-assembly. Do not
crimp the cables.
5. Re-assemble the machine in the reverse order of when the parts were
removed.
NOTICE: Do not crimp the cables.
6. Final Inspection
Inspect your machine to ensure that all hardware is tight and components
are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
7. Plug the machine in and turn the power on to the machine.
38