5. Using a 6mm hex wrench, loosen and remove the indicated hardware
from the Crank Arm and Leg, and set it safely aside for reassembly.
Remove the Leg and Pedal together and set them safely aside for reas-
sembly.
NOTICE: This step may require two people.
6. Using a small standard screwdriver, gently pry the Cap off of the center
of the Crank Cover.
7. Using a #2 Phillips screwdriver, remove the 6 indicated screws (ovals
and arrows) from the Crank Cover.
NOTICE: To assist with re-assembly, observe that the white arrows
are the longer screws.
8. Repeat steps 3-7 on the other side of the machine.
Crank Cover
28