Bowflex BXE116 Service Manual page 114

14. Using a 6mm hex wrench, remove the hardware (indicated) from the
Console Mast. Slightly pull the Mast up and disconnect the cables. Set the
hardware aside for reassembly.
NOTICE: Do not crimp the cables. Do not allow the cables to fall
down into the Main Unit or into the Console Mast. This
step may require two people.
15. Using a small standard screwdriver, gently pry the Cap off of the
center of the Crank Cover.
16. Using a #2 Phillips screwdriver, remove the 6 indicated screws (ovals
and arrows) from the Crank Cover.
NOTICE: To assist with re-assembly, observe that the white arrows
are the longer screws.
17. Repeat steps 15-16 on the other side of the machine.
Console Mast
Cap (removed from
center of Crank Cover)
114
Crank Cover