Bowflex BXE116 Service Manual page 115

18. Measure and mark the position of the Servo Motor Bracket on the
Main Frame.
Brake Arm
19. Insert 2.5" x 10" cardboard between the Brake Magnet and the
Brake Magnet
Flywheel, and tape the cardboard to the Brake Magnet.
Note: Be sure the cardboard covers all of the Brake Magnet.
Flywheel
Tension Spring
Servo Motor Bracket
20. Observe the cable routing to the wiring harness on your machine.
Disconnect the Speed Sensor Cable and Servo Motor Cable from the
wiring harness.
Lower Input/Output
(I/O) Cable
Speed Sensor Cable
Power Inlet
Cable
Potentiometer
Servo Motor Cable
21. Tie the length of string to the end of the Input/Output (I/O) Cable at the
Input/Output (I/O) Cable
top where the Console Mast attached. Remove the zipties that attach the
I/O Cable to the Frame. Pull the cable and string down through the hole
on the side of the Frame so that the string extends through the Frame.
Lift Motor Cable
NOTICE: Hold the Lift Motor Cable so that you do not pull it out of
the Mast. Do not crimp the cables.
22. Untie the string from the I/O Cable Cable.
115