Bowflex BXE116 Service Manual page 35

12. Re-assemble the machine in the reverse order of when the parts
were removed. Tape the cardboard to the new Brake Magnet. Be sure the
cardboard will completely cover the new Brake Magnet before installation.
NOTICE: Do not crimp the cables.
13. Before fully attaching the Shrouds, power up the machine to verify that
the Magnet Arm can move freely, and that the Brake Magnet and Flywheel
do not touch at the maximum resistance level.
Machine is on. Current is active. There is risk of electrical
!
shock. Be sure to keep fingers clear of all pinch hazards when
you change the resistance level.
14. Re-assemble the machine in the reverse order of when the parts were
removed. Put the Left Shroud in position first to align the screws for the
Right Shroud. Install the top screws first. Be sure the tabs in the Motorized
Lift Cover snap into the Side Shrouds.
NOTICE: This step may require two people. Be sure not to crimp
any cables.
Note: Self-tapping screws attach the Shrouds to the Frame.
15. Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
35