Service Mode Procedures
PROCEDURE 3: BUTTON (or KEY) TEST:
1. Hold down the PAUSE/STOP button and Down arrow button together for three seconds while at the Welcome screen to enter the Console
Setup Mode.
2. The Console displays the TOTAL HOURS screen.
3. Hold down the PAUSE/STOP button and Down arrow button together for 3 seconds to go into the Engineering Mode.
4. Push the Down arrow button 14 times until the Console displays "ENTR KEY TEST".
5. Push the Enter button. The Console will display "BUTTON TEST".
6. Using the guide below, push the corresponding button in the order provided. Continue through all the buttons.
Note: If a faulted button is discovered, the Console may need to be powered down to exit the button test.
7. When the button test is complete, the Console will display "DONE", followed by "BUTTON PASS". Push the PAUSE/STOP button to return to
Welcome screen.
8. Flip the power switch to OFF.
CONFIRM
INCLINE
32
33
1
2
3
4
5
6
7
Fat
Manual
Burn
8
START
31
30
9
11
13
Calorie
Calorie
Heart
8 Min.
16 Min.
Burn
Goal
Rate
Interval
Interval
12
10
27
28
User
Enter
25
29
26
24
11
CONFIRM
SPEED
21
20
19
18
17
16
15
Strength
Custom
14
PAUSE
STOP
22
Fan
23
34
RESISTANCE
35