Bowflex BXE116 Service Manual page 63

4. Using a 6mm hex wrench and a 13mm wrench, remove the indicated
hardware from the Lower Handlebar Arm and the Arm Pivot Rod. The
hardware on both ends of the Arm Pivot Rod will need to be held to
remove it.
5. Slightly pull the Handlebar Arm off the machine to expose the Cable
Connections.
6. Disconnect the Handlebar Cable from the Upper Handlebar that goes
into the Console Mast.
7. Remove the Handlebar Arm from the machine.
8. Using a 6mm hex wrench, remove the 4 screws (two indicated, two on
other side of Handlebar) from the Upper Handlebar Arm.
9. Remove the Upper Handlebar Arm from the Lower Handlebar Arm.
10. Re-assemble the machine in the reverse order of when the parts were
removed.
Make sure the Upper Handlebar Arms are secure before you
exercise.
11. Final Inspection
Inspect your machine to ensure that all hardware is tight and components are properly assembled.
Do not use until the machine has been fully assembled and inspected for correct performance in accordance with the Owner's
Manual.
Lower Handlebar Arm
63
Upper Handlebar Arm
Handlebar Cable