21. Disconnect the Lift Motor cable from
the Motor Control Board after noting the
connector locations.
Note: Be sure to note where all cables
attach for re-assembly.
22. Remove the zipties that hold the
cables.
23. Using the 18mm socket and wrench and 18mm open end
wrench, loosen and remove the indicated hex head bolts (by oval)
that attach the Incline Adjuster Assembly to the Lift Motor shaft. Set
the bolts aside for reassembly.
Power Inlet (line)
Power Inlet (neutral)
Lift motor common
(neutral)
Lift Motor CW (line)
Lift Motor CCW (line)
88
Servo Control
Lift Motor Shaft
Incline
Adjuster
Assembly
Lift Motor Assembly
Lift Motor position
potentiometer
Lift Motor Wire (to
Console)