Bowflex BXE116 Service Manual page 89

24. Remove the indicated hardware (by arrow) that attaches the Lift Motor
Assembly to the Frame.
NOTICE: Do not crimp any cables.
25. Remove old Lift Motor assembly, and discard.
26. Install the replacement Lift Motor assembly and hardware to the
Frame.
Note: Do not connect the Incline Adjuster Assembly at this stage.
27. Connect the Lift Motor cable to the proper locations on the MCB. Secure the cables with zipties.
Use the top screw to attach the green Lift Motor ground wire to the Frame. Be sure not to crimp any cables.
28. Turn the power on.
Machine is on. Current is active. There is risk of electrical shock.
29. From the Power Up Mode screen, push and hold down the PAUSE/STOP button and Down arrow button for 3 seconds until the Console displays
the TOTAL RUN HOURS.
30. Push and hold the PAUSE/STOP and DOWN arrow buttons for 3 seconds until the FIRMWARE VERSION STRING is displayed.
31. Push the DOWN arrow button until it displays ENTR INCL TST and push ENTER to start the test.
32. The Console will display INCLINE TEST and work through the numbers 1,2,3 as the motor moves. INCLINE TEST PASS will be displayed when
done and successful.
33. When the motor has stopped turning, adjust the nut (A2) on the shaft (A1) to 35mm above the Lift Motor base, using a ruler or 35mm spacer.
34. Adjust the nut (A2) upward away from the motor base until the holes in the nut align with the
holes in the Incline Adjuster (J) bracket. Install the hex head bolts (K) to secure the bracket to
the nut.
35. Push the ENTER button to exit the TST menu, and then push PAUSE/END to go back to the
Power-Up Mode screen.
36. Push the 15* lift preset button to confirm correct operation. Push the 1* lift preset button to
confirm correct operation.
Disconnect all power and allow to sit for 5 minutes.
Lift Motor Assembly
A1
A2
89
Lift Motor Collar
Nut
35mm
Spacer