Bowflex BXE116 Service Manual page 81

13. Using a 6mm hex wrench, remove the hardware (indicated) from the
Console Mast. Slightly pull the Mast up and disconnect the cables. Set the
hardware aside for reassembly.
NOTICE: Do not crimp the cables. Do not allow the cables to fall
down into the Main Unit or into the Console Mast. This
step may require two people.
14. Tie a length of string to the lower end of the cable being replaced.
Hold the other end of the cable and carefully pull it out of the Console
Mast so that the string extends through the Console Mast.
NOTICE: Do not crimp or pull other cables out of the Console Mast.
15. Untie the string from the old cable and discard it.
16. Tie the lower end of the string coming out of the bottom of the Cable
Mast to the upper end of the replacement cable. Hold the upper end of the
string and carefully pull the new cable through the Cable Mast.
NOTICE: Do not crimp or pull other cables out of the Console Mast.
17. Untie the string from the new cable.
18. Re-assemble the machine in the reverse order of when the parts were
removed.
NOTICE: Do not crimp the cables.
19. Final Inspection
Inspect your machine to ensure that all hardware is tight and components
are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
Console Mast
81