Bowflex BXE116 Service Manual page 74

14. Using a small standard screwdriver, gently pry the Cap off of the
center of the Crank Cover.
15. Using a #2 Phillips screwdriver, remove the 6 indicated screws (ovals
and arrows) from the Crank Cover.
NOTICE: To assist with re-assembly, observe that the white arrows
are the longer screws.
16. Repeat steps 14-15 on the other side of the machine.
17. Using the 15mm open end wrench and 6mm hex wrench, remove the
indicated bolts (with an oval) that attach the Incline Adjuster bracket to the
Lift Motor Assembly. This will allow the Incline Adjuster Assembly to pivot.
Cap (removed from
center of Crank Cover)
Incline Adjuster Assembly
74
Crank Cover
Lift Motor Assembly