Bowflex BXE116 Service Manual page 124

If you are not replacing the Motorized Lift Cover—go to Step 20.
If you are replacing the Motorized Lift Cover — Using a 6mm hex wrench
and a 13mm wrench, remove the 2 screws (indicated by oval, under the
Motorized Lift Cover) that attach the Rail Assembly to the Incline Arm.
19. Remove the Motorized Lift Cover from the Incline Arm, and replace
with the new Cover. Be sure to orient it correctly.
20. Re-assemble the machine in the reverse order of when the parts were
removed. Put the Left Shroud in position first to align the screws for the
Right Shroud. Install the top screws first. Be sure the tabs in the Motorized
Lift Cover snap into the Side Shrouds.
NOTICE: This step may require two people. Be sure not to crimp
any cables.
Note: Self-tapping screws attach the Shrouds to the Frame.
21. Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
124
Incline Arm
Motorized Lift
Cover
Rail Assembly