Upgrade; Wizard - Juniper Advanced Threat Prevention Appliance Cli Command Reference Manual

upgrade

Table 4-23 upgrade
Description
Product(s) CLI
Mode(s)
Syntax
Parameters
Example

wizard

Table 4-24 wizard
Description
Product(s) CLI
Mode(s)
Syntax
Parameters
Example
Upgrade a configured Juniper ATP Appliance Mac OSX Mac Mini device. If the Mac
Mini has already been upgraded to Ubuntu 14.04, this upgrade command will not be
visible at the CLI because it will not be needed.
Please note that this command will only show up for existing customers that have
Mac Mini devices configured as Juniper ATP Appliance Mac OSX detection engine
Secondary Cores (running Ubuntu 13.10). For new customers running Juniper ATP
Appliance Release 3.2.5, each Mac Mini device is shipped with the new Ubuntu
14.04 version already installed, so in this case, the upgrade command will again not
be available from the Juniper ATP Appliance Mac OSX Engine CLI.
Mac Mini OS X Detection Engine
Core
upgrade
built-in
The following example performs a built-in Mac OS X profile update for the Mac
Mini-based Secondary core detection engine.
MAC2(core)# upgrade
Enters the Configuration Wizard. For Configuration Wizard commands and
response, refer to "Configuration Wizard Command Prompt Responses" in the next
section to see command prompts and recommended responses.
All-in-One | Core/CM | Collector | Mac Mini Mac OS X
Basic
wizard
None
The following command starts the configuration wizard.
hostname # wizard
Copyright© 2018, Juniper Networks, Inc.
CLI Command Reference Guide
Updates the guest-image on the Mac OSX Detection
"secondary core.".
83