Setupcheck - Juniper Advanced Threat Prevention Appliance Cli Command Reference Manual

Table 5-21 set traffic-monitoring
Syntax

setupcheck

Table 5-22 setupcheck
Description
Product(s) CLI
Mode(s)
Syntax
Parameters
Example
# set traffic-monitoring-ifc 1gb_ifc
Set the traffic monitoring interface to be the 1G interface.
# set traffic-monitoring-ifc 10gb_ifc
Set the traffic monitoring interface to be the 10G interface.
NOTE After making an interface type change, the system must be rebooted
for the change to take effect.
Checks and reports on basic configuration settings and analysis pipeline setup.
All-in-One | Core CM | Mac Mini OS X Detection Engine
diagnosis
setupcheck {all | report | basic | analysis}
all
report
basic
analysis
The following example checks all basic configuration settings as well as the
analysis pipeline:
JATP (diagnosis) # setupcheck all
Copyright© 2018, Juniper Networks, Inc.
CLI Command Reference Guide
Checks both basic settings and analysis
pipeline.
Shows report of last setupcheck.
Checks basic configuration settings.
Checks the analysis pipeline.
103