Updateimage; Wizard - Juniper Advanced Threat Prevention Appliance Cli Command Reference Manual

updateimage

Table 2-33 updateimage
Description
Product(s) CLI
Mode(s)
Syntax
Parameters
Example

wizard

Table 2-34 wizard
Description
Product(s) CLI
Mode(s)
Syntax
Parameters
Example
Update or correct the guest-image OS profile used by the detection and analysis
behavioral engine.
The updateimage command will update the guest images from the Juniper ATP
Appliance update servers or a USB drive attached to the Juniper ATP Appliance.
All-in-One | Core-CM | Mac Mini OS X Detection Engine
Core
updateimage
built-in
The following example performs a built-in profile update for the Core detection
engine.
JATP (core)# updateimage built-in
Installing image SC-XP-20150617.img...
Previous version of SC-XP-20150617.img exists.
Checking integrity...
Image SC-XP-20150617.img is already installed
Installing image SC-W7-20150521.img...
Previous version of SC-W7-20150521.img exists.
Checking integrity...
Image SC-W7-20150521.img is already installed
Enters the Configuration Wizard. For Configuration Wizard commands and
response, see "Configuration Wizard for the All-in-One Server" in the next section to
follow command prompts and recommended responses.
All-in-One | Core/CM | Collector | Mac Mini Mac OS X
Basic
wizard
None
The following command starts the configuration wizard.
hostname # wizard
Copyright© 2018, Juniper Networks, Inc.
CLI Command Reference Guide
Updates the guest-image on the detection Engine.
35