Restore - Juniper Advanced Threat Prevention Appliance Cli Command Reference Manual

restore

Table 3-14 restore
Description
Product(s) CLI
Mode(s)
Syntax
Parameters
Note: vCore for AWS
does not use the
following CLI
commands:
restore hostname
restore network
Example
Restores the system configuration to the factory default settings.
All-in-One | Collector | Core CM | Mac Mini OS X Detection Engine
Server
restore [support | firewall {backup | default} | hostname
| network]
support
firewall
{backup |
default}
hostname
network
The following example restores the system.
JATP # restore
This next example restores the SSH login "support" password to the default.
JATP # restore support password
Restore the default suppport password? (Yes/No)? yes
support password was restored successfully!
Copyright© 2018, Juniper Networks, Inc.
Restores the default support password setting for SSH
remote login (set during initial installation per license).
See also (server)# set (server mode) support
Restores the firewall settings from either the previous
backup, or from the default factory settings.
Whitelist rules rely on normal service shutdown to be
backed up.Powering off a VM directly will lose the whitelist
state as rules cannot be saved in that case
Restores the system's hostname to the factory default
hostname.
Restores the IP address and DNS settings to the
factory default settings.
WARNING: This command option removes the current
IP address and DNS settings, and reloads the default
values for these settings.
CLI Command Reference Guide
47