Table of Contents
Advertisement
Juniper Advanced Threat Prevention Appliance
Table 3-27 wizard
Syntax
Parameters
Example
Configuration Wizard for the CoreCM Server
NOTE
Enter CTRL-C to exit the Configuration Wizard at any time. If you exit without completing the
configuration, you will be prompted again whether to run the Configuration Wizard.
You may also rerun the Configuration Wizard at any time with the CLI command wizard.
Configuration Wizard Prompts
Use DHCP to obtain the IP address and DNS
server address for the administrative interface
(Yes/No)?
Note: Only if your DHCP response is no,enter
the following information when prompted:
a. IP address (no CIDR format)
b. Netmask
c. Enter a gateway IP address for this
management (administrative) interface:
d. Enter primary DNS server IP address.
e. Do you have a secondary DNS Server
(Yes/No).
f. Do you want to enter the search
domains?
g. Enter the search domain (separate
multiple search domains by space):
Restart the administrative interface (Yes/No)?
60
wizard
None
The following command starts the configuration wizard.
hostname # wizard
Copyright© 2018, Juniper Networks, Inc.
Customer Response Actions
We strongly discourage the use of DHCP
addressing because it changes dynamically. A
static IP address is preferred.
Recommended: Respond with no:
a. Enter an IP address
b. Enter a netmask using the form
255.255.255.0.
c. Enter a gateway IP address.
d. Enter the DNS server IP address
e. If yes, enter the IP address of the secondary
DNS server.
f. Enter yes if you want DNS lookups to use a
specific domain.
g. Enter search domain(s) separated by spaces;
for example: example.com lan.com dom2.com
Enter yes to restart with the new configuration
settings applied.
Advertisement
Table of Contents
