Set System-Alert (Server Mode) - Juniper Advanced Threat Prevention Appliance Cli Command Reference Manual

set system-alert (server mode)

Table 2-25 set system-alert
Description
Product(s) CLI
Mode(s)
Syntax
Parameters
Example
Configure the traffic threshold and checking interval for the Collector "monitored
traffic" health status.
When the monitored traffic of a collector within the checking interval time is lower
than the threshold, a system health alert is generated. You can send an email
notification of the alert if email notifications of system health events are
configured.
All-in-One | Core CM
Server, See Also: set (diagnosis mode); set traffic-filter (collector mode); show
set system-alert traffic <integer> time <interval>
NOTE Note that both "traffic" and "time" parameters are required in order to
set the threshold for both the minimum traffic and time.
traffic
- the minimum traffic (in KB)
interval
- the checking interval (in minutes)
JATP (server) # set system-alert traffic 100 time 30
This example sets the system alert such that, if the total monitored traffic of a
collector within the last 30 minutes dips lower than 100KB, then a system health
alert will be generated (and users will receive an email notification of the alert if
email notifications are configured for system health events).
By default this alert is disabled, and users must set the minimum traffic and interval
in order to enable it. Also note that all bytes seen on Ethernet frames are counted in
the traffic.
The minimum interval for the "set system-alert traffic" time interval command is 10
minutes. If the minimum interval is set to less than 10 minutes, no alerts will be
triggered.
Copyright© 2018, Juniper Networks, Inc.
CLI Command Reference Guide
29