Juniper Advanced Threat Prevention Appliance Cli Command Reference Manual page 59

Table 3-18 set
firewall {all
<backup | flush>
| whitelist <add
| delete |
flush>}
hostname string
ip interface
{management |
alternate-
exhaust} <dhcp |
address |
netmask |
gateway}
ntpserver
passphrase
string
password
proxy {config
<all|http> |
enable <on|off>
| remove
<all|http>}
timezone string
uipassword
Examples
Backs up or flushes (clears) all current iptables
for a firewall, or adds, deletes or flushes the
current iptables whitelist-specific settings for the
firewall.
The "add" option adds an IP address to the
iptables outbound whitelist.
# set firewall whitelist add
10.1.1.1
Sets the system's host name.
Sets the IP address, netmask, or default gateway,
or enables DHCP for the management or
alternate-exhaust interface.
Sets the Network Time Protocol (NTP) server.
Sets the device key password; enter a string.
Sets a new password for the CLI administrator.
Config, enable/disable, or remove "all" proxy configs,
or remove an HTTP-specific proxy server.
Tip: Config the proxy for "all" protocols first, and then
change HTTP proxy as needed.
Sets the timezone for the device.
Sets a new admin password for CM Web UI access.
The following example enables a proxy server.
JATP (server)# set proxy enable on
Copyright© 2018, Juniper Networks, Inc.
CLI Command Reference Guide
51