Table of Contents
Advertisement
Preface
This preface contains the following sections:
•
About This Guide on page 1
•
Organization on page 1
•
Typographical Conventions on page 2
•
Related Documentation on page 2
About This Guide
This guide describes the commands that make up the command-line interface (CLI) of the Juniper ATP
Appliance.
This guide is intended for system administrators responsible for deploying, operating, and maintaining the Juniper
ATP Appliance.
Organization
This guide is organized as follows:
•
Chapter 1, "Introduction"—Includes an overview of CLI usage, CLI Modes and information about how to
access the Juniper ATP Appliance Command Line Interface.
•
Chapter 2, "All-in-One CLI Commands"—Provides information about system commands for updating the
product boot images, setting configurations, and defining system-level settings for Collector and
Detection Engine interfaces and network deployment services.
•
Chapter 3, "Core/CM Server CLI Commands"—Provides information about commands available to the
Core and Central Manager for all hardware appliance, software appliance, and virtual appliance models,
including the commands used to manage Detection Engines and Juniper ATP Appliance system
configuration.
•
Chapter 4, "Mac OS X Engine CLI Commands"—Provides information about Mac Mini Mac OS X Detection
Engine-specific commands for configuration and status monitoring.
•
Chapter 5, "Traffic Collector CLI Commands"—Provides information about the Juniper ATP Appliance
Traffic Collector commands available for identifying, monitoring, and configuring distributed Collector
hardware, software and virtual appliances.
•
Chapter 6, "Glossary of Terms"—Provides a set Juniper ATP Appliance-specific as well as cybersecurity
industry terms and definitions.
Copyright© 2018, Juniper Networks, Inc.
1
Advertisement
Table of Contents
