Introduction; Accessing The Cli; Hardware Appliance Access Via The Console - Juniper Advanced Threat Prevention Appliance Cli Command Reference Manual

CHAPTER 1

Introduction

This chapter explains how to use the Juniper ATP Appliance command line interface (CLI) to configure and
administer a Juniper ATP Appliance.
This chapter contains the following sections:
•
"Accessing the CLI" in the next section
•
CLI Help and Keyboard Shortcuts on page 16
•
CLI Modes on page 17

Accessing the CLI

You have the option of accessing the Juniper ATP Appliance CLI in either of two ways:
•
Console
• SSH
NOTE Always use the latest version of Putty for SSH operations, if using Putty as an SSH client.

Hardware Appliance Access via the Console

To access the Juniper ATP Appliance CLI using the console port:
1. Connect your computer's serial port to the DB-9 console port on the Juniper ATP Appliance.
2. Open a terminal program such as Console on Mac OS X, HyperTerminal on Windows, or Minicom on Linux.
3. Configure the terminal program serial communication settings as follows:
› Bits per second: 960
› Data bits: 8
› Stop bit: 1
› Parity: None
4. At the CLI prompt, enter your username and password. By default, the admin user name is admin and the
password is 1JATP234
Be sure to change the default password for the admin account after initial setup;
the password must be at least 8 characters in length.
5. To launch the configuration wizard, enter the command
.
Copyright© 2018, Juniper Networks, Inc.
wizard
.
3