Show (Diagnosis Mode) - Juniper Advanced Threat Prevention Appliance Cli Command Reference Manual

show (diagnosis mode)

Table 2-29 show
Description
Product(s) CLI
Mode(s)
Syntax
Parameters
Example
Sets the logging levels for Juniper ATP Appliance components from diagnosis mode.
See Also: shutdown; show (core mode)
All-in-One | Collector | Core CM | Mac Mini OS X Detection Engine
diagnosis
show
device
{collectorstatus | |
corestatus |
slavecorestatus}
protocol {web |
email}
objects
logging
log error traceback
log error last
<integer: number of
lines to display>
The following example displays the connected Traffic Collector status.
JATP(diagnosis)# show device collectorstatus
<cr>
JATP (diagnosis)# show device collectorstatus
WEB_COLLECTOR
=====================================================
====
IP : 10.2.9.68
Enabled : True
Last Seen : 2015-07-25 15:13:17.967000-07:00
Install Date : 2015-06-25 19:03:38-07:00
=====================================================
====
IP : 10.2.20.3
Enabled : True
Last Seen : 2015-07-28 11:07:42.046000-07:00
Install Date : 2013-11-14 09:25:39-08:00
This example displays the log error traceback
JATP(diagnosis)# show log error traceback
<cr>
Copyright© 2018, Juniper Networks, Inc.
CLI Command Reference Guide
Display connected device statistics for Traffic
Collector, CoreCM, or Mac Mini Detection Engine
Secondary "slave core."
Displays the session counts for network web or
email protocols.
Displays the current number of file objects.
Displays the currently-configured logging level.
See Also: set traffic-filter (collector mode) logging
Displays only the tracebacks (if any) generated by
Juniper ATP Appliance OS process error logs. A
traceback is a stack of functions that were
executing when an error condition was
encountered.
Displays n [1-1000] lines of the contents of the
common log file.
Example: show log error last 12
33