Basic Mode Commands; Core Mode Commands - Juniper Advanced Threat Prevention Appliance Cli Command Reference Manual

CHAPTER 4
Mac OS X Engine CLI
Commands
This chapter describes the CLI commands available for the Mac Mini Mac OS X "Secondary Core" detection
engine device. There is no Collector Mode on this device.
NOTE You must enclose non-alphabet characters in double quotes in CLI commands.

Basic Mode Commands

Use general system commands to configure the appliance, view appliance history, enter other CLI modes, obtain
help with CLI syntax, and to exit the CLI session.
The general commands are:
•
core on page 66
• diagnosis on page 66
• exit on page 67
• help on page 68
• history on page 69
• server on page 72
• wizard on page 83
Refer to the respective chapters in this guide to review Collector Mode, Diagnosis Mode and Server Mode
commands per device-- All-in-One, Mac OS X Engine, Traffic Collector and CoreCM.

Core Mode Commands

•
exit on page 67
•
help on page 68
•
history on page 69
•
show (core mode) on page 77
•
updateimage on page 81
Copyright© 2018, Juniper Networks, Inc. 63