Juniper Advanced Threat Prevention Appliance Cli Command Reference Manual page 36

Table of Contents

Juniper Advanced Threat Prevention Appliance

Table 2-24 set

hostname string

ip interface

{management |

alternate-

exhaust} <dhcp |

address |

netmask |

gateway}

ntpserver

passphrase

string

password

proxy {config

<all|http> |

enabled <on|off>

| remove

<all|http>}

timezone string

uipassword

Example

Sets the system's host name.

Sets the IP address, netmask, or default gateway,

or enables DHCP for the management or

alternate-exhaust interface.

Sets the Network Time Protocol (NTP) server.

Sets the device key password; enter a string.

Sets a new password for the CLI administrator.

Config, enable/disable, or remove "all" proxy configs,

or remove an HTTP-specific proxy server.

TIP

Tip: Config the proxy for "all" protocols first, and

then change HTTP proxy as needed.

Sets the timezone for the device.

Sets a new admin password for CM Web UI access.

The following example disables the CLI timeout counter.

JATP (server)# set cli timeout 0

The following example enables support:

JATP (server)# set support enable

Table of Contents