Juniper Advanced Threat Prevention Appliance Cli Command Reference Manual page 83

Table of Contents

Table 4-15 server mode

ip interface

{management |

alternate-

exhaust} <dhcp |

address |

netmask |

gateway}

ntpserver

password

proxy {config

<all|http> |

enabled <on|off>

| remove

<all|http>}

timezone {US/

Eastern | US/

Central | US/

Mountain

uipassword

Example

Sets the IP address, netmask, or default gateway,

or enables DHCP for the management or

alternate-exhaust interface.

Sets the Network Time Protocol (NTP) server.

Sets a new password for the CLI administrator.

Config, enable/disable, or remove "all" proxy configs,

or remove an HTTP-specific proxy server.

Tip: Config the proxy for "all" protocols first, and then

change HTTP proxy as needed.

Show the current timezone; example:

set timezone US/Pacific

set timezone <tab> shows options

TIP:

Sets a new admin password for CM Web UI access.

The following example sets an ip address for the device management interface

eth0.

JATP# set ip interface 10.1.1.1

CLI Command Reference Guide

Table of Contents