All-In-One Cli Commands; Basic Mode Commands - Juniper Advanced Threat Prevention Appliance Cli Command Reference Manual

CHAPTER 2

All-in-One CLI Commands

This chapter describes the administration commands for a Juniper ATP Appliance All-in-One server appliance,
software appliance or virtual appliance.
These commands are used to configure the Juniper ATP Appliance All-in-One appliance, manage configurations,
and set system-level settings for interfaces, network services, and SIEM integration.
NOTE You must enclose non-alphabet characters in double quotes in CLI commands.

Basic Mode Commands

Use general system commands to configure the appliance, view appliance history, enter other CLI modes, obtain
help with CLI syntax, and to exit the CLI session.
The general commands are:
•
cm on page 12
•
core on page 13
•
collector on page 12
•
diagnosis on page 14
•
exit on page 14
•
help on page 16
•
history on page 17
•
server on page 20
•
wizard on page 35
Refer to the sections in this guide to review CM Mode, Collector Mode, Core Mode, Diagnosis Mode, Server Mode
and Wizard mode commands per device-- All-in-One, CoreCM, Traffic Collector and Mac OS X Detection Engine
on a Mac Mini.
Copyright© 2018, Juniper Networks, Inc. 9