Restore; Server - Juniper Advanced Threat Prevention Appliance Cli Command Reference Manual

Juniper Advanced Threat Prevention Appliance

restore

Table 2-15 restore
Description
Product(s) CLI
Mode(s)
Syntax
Parameters
Note: vCore for AWS
does not use the
following CLI
commands:
restore hostname
restore network
Example

server

Table 2-16 server
Description
Product(s) CLI
Mode(s)
Syntax
Sub-Commands
20
Restores the system configuration to the factory default settings.
This will only reset the password to default temporarily.
All-in-One | Collector | Core CM | Mac Mini OS X Detection Engine
Server
restore [support | firewall {backup | default} | hostname
| network]
Whitelist rules rely on normal service shutdown to be backed up.Powering off a VM
directly will lose the whitelist state as rules cannot be saved in that case.
support
firewall {backup | default} Restores the firewall settings from either the pr
hostname
network
The following example restores the system.
JATP# restore
This next example restores the SSH login "support" password to the default.
JATP
# restore support password
Restore the default support password? (Yes/No)? yes
support password was restored successfully!
Enters the server configuration mode.
See Also: collector
All-in-One | Collector | Core/CM | Mac Mini Mac OS X
Basic
server
exit; help; history; ifrestart; ping; reboot; restore; set (server mode);upgrade
Whitelist rules rely on normal service shutdown to be backed up.Powering off a VM
directly will lose the whitelist state as rules cannot be saved in that case.
Copyright© 2018, Juniper Networks, Inc.
Restores the default support password setting
remote login (set during initial installation per l
See also (server)# set (server mode) support
backup, or from the default factory settings.
Restores the system's hostname to the factory
hostname.
Restores the IP address and DNS settings to th
factory default settings.
WARNING: This command option removes the
IP address and DNS settings, and reloads the d
values for these settings.