Juniper Advanced Threat Prevention Appliance Cli Command Reference Manual page 57

Table 3-17 set system-alert
Syntax
Parameters
Example
set system-alert traffic <integer> time <interval>
NOTE Note that both "traffic" and "time" parameters are required in order
to set the threshold for both the minimum traffic and time.
traffic
- the minimum traffic (in KB)
interval
- the checking interval (in minutes)
JATP (server) # set system-alert traffic 100 time 30
This example sets the system alert such that, if the total monitored traffic of a
collector within the last 30 minutes dips lower than 100KB, then a system health
alert will be generated (and users will receive an email notification of the alert if
email notifications are configured for system health events).
By default this alert is disabled, and users must set the minimum traffic and interval
in order to enable it. Also note that all bytes seen on Ethernet frames are counted in
the traffic.
The minimum interval for the "set system-alert traffic" time interval command is 10
minutes. If the minimum interval is set to less than 10 minutes, no alerts will be
triggered.
Copyright© 2018, Juniper Networks, Inc.
CLI Command Reference Guide
49