Core/Cm Server Cli Commands; Basic Mode Commands; Cm Commands - Juniper Advanced Threat Prevention Appliance Cli Command Reference Manual

CHAPTER 3

Core/CM Server CLI Commands

This chapter describes the commands for available for Juniper ATP Appliance Core/CM or vCore servers. These
commands are used to configure devices and software, manage security events, and show system information
and status.
You must enclose non-alphabet characters in double quotes in CLI commands.

Basic Mode Commands

Use general system commands to configure the appliance, view appliance history, enter other CLI modes, obtain
help with CLI syntax, and to exit the CLI session.
The general commands are:
•
cm on page 39
•
core on page 40
•
diagnosis on page 41
•
exit on page 42
•
help on page 43
•
history on page 44
•
server on page 48
•
wizard on page 59
Refer to the respective sections in this guide to review Diagnosis Mode, CM Mode, Collector Mode and Server
Mode commands per product device.

CM Commands

•
exit on page 42
•
help on page 43
•
history on page 44
•
upgrade on page 58
Copyright© 2018, Juniper Networks, Inc. 37